- Particularly energy-efficient lamp with a power consumption of only 4 watts - For all lamps with commercially available G9 fittings - More economical in use and generates less heat than commercially available halogen plug-in bulbs - Very low consumption, ideal for permanent lighting such as a night light in bedrooms or for walkways - Also suitable as table or task lighting when using multiple LED lamps - Fully insulated, attractive plastic housing Consumer Advice: The LED lamp is designed for use in open lamps. The heat generated by the lamp during use can thus be released into the environment. The lifespan forecast is based on this type of use. When used in enclosed lamps, the lack of cooling leads to a shorter lifespan. Only to be used in luminaires suitable for this purpose. Before replacing a lamp, it must be completely cooled down and the mains voltage must be switched off. Damaged lamps must be replaced immediately. No liability for improper use With some dimmers, the lamp may malfunction (flickering, noises). Simultaneous use of LED bulbs and standard incandescent bulbs, or of different types of LED bulbs with a single dimmer cable, is not possible. If noises are heard in dimmers that were not observed with incandescent bulbs: the dimmer is not suitable for LED bulbs. Cord dimmers (dimmers integrated into the power cable) require a separate on/off switch, as they cannot always be adjusted all the way to 0. Observe the minimum load of the dimmer; otherwise, it may not work or may not work correctly. Single dimmers usually require 60W to 400W. With built-in dimmers, the base brightness must be set high enough; otherwise, the LED bulb may not switch on. Always dim slowly and evenly, not in jerky or rapid motions. Only incandescent bulb dimmers are permitted – no dimmers for transformers, etc. Touch dimmers are usually not suitable. An incorrect dimmer can irreparably damage bulbs.